Testimonials

Yes,  we even get Testimonials along with our email…

Subject MOTA-X

From : Richard

Ian,

The thumb drives arrived yesterday so I plugged them in and installed the software and tried to optimize the exhausts of a couple of our recent projects and the results were impressive to say the least.

the PC I loaded it on a windows 10 OS on an i7 with 16Gb of RAM and a SSD for fast disk access and it flies.  Typical times so far are in the 5-10 minute range but I wasn’t timing it.  That is the cheapest HP I have ever bought.

I still have no ability to simulate or evaluate 3 into 1 pipes, but this is a huge step forwards. 

Thanks, Merry Christmas
Richard

 

Subject : MOTA version 6.00
From : Ken,  UK

Hi Ian,

Many thanks for sending out so swiftly.  May I congratulate you on a job well done.   The Windows version is a revelation.  Its much easier to use and more convenient to retrieve info from another file and input it into MOTA.

It also runs so much quicker on my desktop than in my DOS environment.  The adding of more exhaust sections to keep up with more modern trends is a welcomed addition as is the new section in the intake. 

Once again a cracking product and I will be recommending it to people over here.

Regards,     
Ken.

 

Subject: MOTA SOFTWARE
From: Pierre,  Canada

Hello Ian,

I ordered your MOTA a couple of months ago (and I still don’t speak English very well ).   I played with it many hours, probably 200 and more.  And to be honest, it’s amazing !!

I input the data of my stock snowmobile engine ( 600cc 3 cyl ) and I got 39.7 hp at 8,500 rpm ( x3 = 119.1 hp ).  My engine is rated at 120 – 122 hp at 8500 rpm !!  VERY CLOSE.

Thanking you.

Subject: MOTA SOFTWARE
From:  Ray, Federal Way, WA, USA

Hello Ian,

I just wanted to let you know that your MOTA v4.44 2-stroke engine software is great. I have been using it to study expansion chamber design for 2-stroke engines.  I have read many books and SAE papers on this subject but MOTA has helped my understanding tremendously.  By changing a expansion chamber parameter and then running a simulation I have gotten a better feel for how the pipe design changes the torque and power curves.

Thanks,  Ray. 

 

Subject: MOTA SOFTWARE

From:  Ray, Federal Way,  WA , USA

I just wanted to give you some feedback on your new version of MOTA.  I just got around to installing and trying out your new version 5.00.  It is a big improvement   over version 4.44 which I purchased last December.  The new user interface is much easier and quicker to use.  I also liked the one input file format which allows me to store all the data in one file. 

I also noticed that the performance curves were much closer to dyno curves that I saved from several magazines.  These torque and power curves are much better behaved compared to the version 4.44 curves.

Thanks again.

 

Subject: MOTA SOFTWARE
From: Canada

To Ian,

Thank you for your first MOTA newsletter.  I have recently used your software to optimise the tuning of a Comer K80 for one of our junior drivers, some people believe the motor is illegal, it offers comparable performance to motors prepared by one of the top tuners in the NW USA.

Your software has allowed me to test some ideas and to get a real understanding where to make changes.

Last week I was asked to compare a KSI direct drive pipe vs. the IAME pipe on a Yamaha in order to give the driver an idea of what characteristics to look for when he was comparing their performance on the circuit. He found the information very helpful.

I now have people asking me to tune their motors, much to the worry of my fellow tuners.

Thanks.

Get in touch with us to find out more